6063 T5 Aluminum Cable Ladder 200mm-700mm Width IEC 61537 For Data Halls Telecom Buildings

aluminum cable ladder IEC 61537 is the 300 mm aluminum route for projects that specify the international standard and want the weight and corrosion advantages of an extruded alloy rather than a steel section. It is the specification most often found in data halls, telecom buildings and light industrial plants.

The ladder is extruded from 6063 T5 aluminum in 300 mm usable width, with rail heights of 100 mm or 150 mm, rung pitch of 225 mm or 300 mm and modules of 2 m or 3 m. Rungs are pressed or riveted into the rails on a fixture, so the ladder stays straight and the rung spacing remains within tolerance across the length.

IEC 61537 defines the load and deflection basis and the continuity requirement, so the designer can publish a support spacing that the contractor installs to and the inspector can verify. For the aluminum version the continuity is achieved through bonded couplers at each joint, and the kits are supplied with the order.

The alloy brings the practical benefits: it does not rust, so no paint or galvanizing repair is needed; it weighs around a third of steel, so a single installer can handle a module; and it is non magnetic, so it does not affect data or instrument signals and does not heat beside single core cables. Anodizing adds a hard oxide layer for humid rooms.

BENDIN extrudes and fabricates this ladder in house with 7000 m per working day, 180 staff and thirty years of cable route experience, exporting 60 to 70 percent of output to data centre and industrial contractors. Alloy, wall thickness and straightness are checked on every batch, and custom widths can be produced to the layout.

Minimum order 600 pcs, 25 working day delivery, 10 to 30 USD per piece, pallet packing, terms L/C, D/P or T/T. Send the cable load and the support grid and we will return the rail height, the deflection calculation and the accessory list.

BENDIN holds ISO 9001 quality certification and issues CE Declarations of Conformity. The standards above state the design and test basis of this product; third party test reports or national approvals are supplied on request and are not implied unless confirmed in the contract.

Dimensions, rung spacing and surface treatment are produced to project drawings. Load and deflection calculations are issued for spans above 3 m.

• Data centres and telecom buildings
• Industrial power and control routes
• Commercial risers and plant rooms
• Laboratories and clean rooms
• Light industrial and warehouse ceilings

Q: Why choose aluminum in a riser?
A: Low mass reduces the load on floor penetrations and supports, and the alloy does not rust in a humid riser even without painting.

Q: How is continuity maintained?
A: Bonding kits at each coupler keep the earthing path continuous, and continuity resistance is measured and recorded before handover.

Q: Can the width be changed to 450 mm?
A: Yes. 200, 450 and 600 mm widths are produced from the same profile family with matching fittings.

Q: What is the minimum order?
A: Minimum order 600 pcs, delivery 25 working days, prices from 10 to 30 USD per piece.