Pre Galvanized Ladder Cable Tray Indoor Rated Zinc Coated Customized Color

Pre-Galvanized Cable Ladder Indoor Rated is the economic route for dry internal installations: warehouses, workshops, offices and plant rooms, where a zinc coated steel ladder gives clean corrosion protection at a lower cost than hot dip galvanizing and does not need painting.

The ladder is formed from pre-galvanized steel strip, so the zinc coating is present before the section is roll formed and the cut ends are the only exposed steel. Widths run from 100 mm to 900 mm, rail heights from 50 mm to 150 mm and rung pitch from 225 mm to 300 mm, in 3 m modules with a full range of bends, tees and brackets.

Pre-galvanized is the right specification indoors because the environment does not demand a heavy coating: in a dry C1 or C2 interior the zinc layer gives a long service life, the surface is smooth and bright for visible areas, and the material cost is below a hot dip route of the same size. For humid or outdoor work the same geometry is supplied hot dip galvanized.

The wire ladder rack format is part of the appeal: cables are laid in from above, tied at each rung, and the open structure allows inspection from below and easy addition of a circuit later. It is one of the fastest support systems to install in a ceiling void or above a mezzanine.

BENDIN produces this ladder at up to 100000 m per week with 180 staff and thirty years of cable support manufacturing, exporting 60 to 70 percent of output to contractors and distributors. Zinc coating mass, rung spacing and straightness are checked on every batch, and custom colours and widths are available.

Minimum order 50 m, 10 to 20 working day delivery, prices on request, pallet packing, terms T/T, Western Union or L/C. Tell us the indoor environment, the cable load and the ceiling type and we will confirm the width, the coating and the bracket schedule.

BENDIN holds ISO 9001 quality certification and issues CE Declarations of Conformity. The standards above state the design and test basis of this product; third party test reports or national approvals are supplied on request and are not implied unless confirmed in the contract.

Dimensions, rung spacing and surface treatment are produced to project drawings. Load and deflection calculations are issued for spans above 3 m.

• Warehouse and logistics ceilings
• Workshops and light manufacturing
• Office and retail back of house
• Plant rooms and service voids
• Mezzanine and racking cable routes

Q: When is pre-galvanized enough?
A: In dry C1 or C2 interiors such as warehouses, offices and workshops. For humid, outdoor or coastal areas we supply the same geometry hot dip galvanized.

Q: Is the cut end a corrosion risk indoors?
A: It is minimal in a dry interior. Where cut ends are exposed we supply touch up compound or pre cut lengths to avoid site cutting.

Q: Can I add circuits after installation?
A: Yes. Cables are laid in from above and tied at each rung, so a new circuit can be added without removing covers.

Q: What is the minimum order?
A: Minimum order 50 m, delivery 10 to 20 working days, pallet packing on T/T, Western Union or L/C terms.