Fiberglass Ladder Cable Tray Isophthalic Polyester 50mm-200mm Depth Pultruded

Fiberglass Cable Ladder For Data Center is the lightweight composite route for halls where the ceiling structure is already working hard and every kilogram of cable support counts: pultruded glass reinforced plastic replaces steel with a section that carries the same cable mass at a fraction of the dead load.

The ladder is produced by pultrusion from E glass roving in a fire retardant isophthalic or vinyl ester resin, with widths from 50 mm to 1200 mm, rail heights of 50 mm to 200 mm and rung pitch of 225 mm, 300 mm or 450 mm, in 3 m and 6 m modules. Rungs are bonded and mechanically fixed so the joint does not rely on adhesion alone.

In the data hall the composite brings three practical advantages: it does not conduct, so no bonding is required and a dropped section cannot create a fault path; it does not shield radio, so WiFi and DAS coverage stays clean; and it does not corrode, so the humid, chilled environment cannot degrade the support over a twenty year life.

Installation is quicker because the modules are light and can be cut on site with a diamond blade without destroying a coating, and because the fitting family is moulded to match the rail so there is no field drilling. Support spans of 1.5 m to 4.5 m are typical, with engineered spans up to 9 m for light loads.

BENDIN pultrudes and assembles FRP ladder at 10000 m per week with 180 staff and thirty years of cable support experience, exporting 60 to 70 percent of output to data centre, chemical and marine contractors. Resin cure, colour and rung strength are checked on every batch before packing.

Minimum order 100 m, 15 to 25 working day delivery, 15 to 50 USD per metre, pallet packing, terms L/C, D/A, D/P or T/T. Send the hall layout, the load per metre and the fire class and we will return the support spacing, the fittings list and the documentation package.

BENDIN holds ISO 9001 quality certification and issues CE Declarations of Conformity. The standards above state the design and test basis of this product; third party test reports or national approvals are supplied on request and are not implied unless confirmed in the contract.

Dimensions, rung spacing and surface treatment are produced to project drawings. Load and deflection calculations are issued for spans above 3 m.

• Data centres and colocation halls
• Telecom and edge rooms
• Control rooms and laboratories
• Chemical and water treatment plants
• Marine and coastal technical buildings

Q: How much lighter than steel is it?
A: Approximately a quarter of the weight, which reduces ceiling dead load and lets a two person crew install a module without a hoist.

Q: Is on site cutting acceptable?
A: Yes, with a diamond blade. The cut face needs no coating repair because the material is homogeneous.

Q: Can widths be customised?
A: Widths from 50 mm to 1200 mm and rail heights from 50 mm to 200 mm are produced to drawing, with matching fittings.

Q: What is the minimum order?
A: Minimum order 100 m, delivery 15 to 25 working days, prices from 15 to 50 USD per metre.