300mm Aluminum Cable Ladder 6063 T5 Mill Finish 3m-6m Section Length Options

Aluminum Cable Ladder 300mm is the working width most telecom and coastal projects settle on: wide enough for a mixed bundle of power, fibre and control cable, narrow enough to handle, hoist and align from a two point scaffold. The rung ladder keeps every cable visible for inspection and lets one technician add a drop without opening a cover plate.

The 300 mm usable width is produced from 6063 T5 extrusion with 100 mm or 150 mm rails and 225 mm or 300 mm rung pitch, in 2 m and 3 m modules weighing from 3.5 kg per metre. Low mass is not a side effect of the alloy choice: it is what allows a single installer to carry, position and bolt a section on a rooftop frame or a coastal monopole.

Aluminum behaves differently from steel under marine air. The oxide layer re forms immediately after a scratch and there is no zinc to consume, so the section stays intact in salt spray zones where galvanized steel would show red rust at cut ends and drill holes. For splash zones we recommend anodizing or a marine grade powder coat over the extrusion.

The 300 mm width matches the cable layout used on 5G rooftop sites, microwave huts, small cell cabinets and offshore telecom platforms, and accepts standard bends, tees, reducers and wall brackets so a route can turn and rise without site fabrication or hot work permits.

BENDIN produces this ladder on its own extrusion and fabrication lines, shipping 7000 m per working day with 60 to 70 percent of output exported. Thirty years of cable route experience, 180 production staff and ISO 9001 control mean consistent wall thickness, straight rails and rung positions that line up on site, order after order.

Minimum order 600 pcs, 25 working day delivery, pallet packing, L/C, T/T or D/P terms. Tell us the route length, the ambient chloride level and the cable load and we will confirm alloy, surface finish and support spacing in a single drawing package.

BENDIN holds ISO 9001 quality certification and issues CE Declarations of Conformity. The standards above state the design and test basis of this product; third party test reports or national approvals are supplied on request and are not implied unless confirmed in the contract.

Dimensions, rung spacing and surface treatment are produced to project drawings. Load and deflection calculations are issued for spans above 3 m.

• 5G rooftop and monopole telecom sites
• Telecom huts and small cell cabinets
• Coastal, island and marine installations
• Solar and wind farm cable routes
• Port lighting and shipyard circuits

Q: How much does the 300 mm ladder weigh?
A: From 3.5 kg per metre for a 100 mm rail, rising to about 4.8 kg per metre for the 150 mm rail, so one technician can carry and position a 2 m or 3 m module.

Q: Will it corrode on a coastal monopole?
A: The alloy forms a self renewing oxide film and has no zinc to consume. For splash zones we recommend anodizing or a marine grade powder coat over the extrusion.

Q: Do you supply bends and wall brackets?
A: Yes. Bends, tees, reducers and wall brackets are produced to match the 300 mm series so the route turns and rises without site fabrication.

Q: What is the lead time for a 600 pcs order?
A: Delivery is 25 working days from drawing approval, with mill certificates per lot and pallet packing for sea freight.