Data Center Ladder Rack 200mm-700mm Width Mill Finish for Server Room Runs

Aluminum Cable Ladder Data Center is the overhead pathway that carries feeder and branch power above server rows, where weight, magnetic interference and future reconfiguration decide the design more than raw strength. The open rung profile lets hot air leave the cable bundle immediately, so conductor temperature and derating factors stay inside the limits set by the electrical designer.

Rails are extruded from 6063 or 6061 alloy to EN 755 and assembled with pressed or riveted rung connections that keep the section straight without a weld heat affected zone. Standard widths run from 200 mm to 700 mm with 100 mm or 150 mm rail heights and rung spacing of 225 mm or 300 mm, cut into 2 m or 3 m modules for two person handling inside a live hall.

Non magnetic aluminum does not concentrate flux around busbars and does not carry induced circulating currents, which matters when 400 A feeders run parallel to data cabling. The alloy forms a natural oxide film that resists condensate and humid air, so no paint is needed and no coating can chip into a raised floor void or a containment zone.

Installation follows the white space rhythm: trapeze hangers from the structural grid, quick couplers between modules, drop brackets over each rack row, and pre formed bends and tees for aisle changes. Because mass per metre is roughly a third of an equivalent steel ladder, one installer can position a 3 m section and the ceiling structure sees a far smaller dead load.

BENDIN extrudes, finishes and fabricates this ladder in house, with 7000 m of finished ladder leaving the line each working day and 60 to 70 percent of output exported to data centre contractors, telecom operators and EPC firms. Three decades of cable route engineering, a 180 person production team and ISO 9001 process control mean the module you receive matches the drawing you approved.

Supply is quoted from 600 pcs per line with 25 working day delivery, packed on pallets for crane offloading, on L/C, T/T or D/P terms. Share the rack layout and cable weights and we will return a support spacing plan, a deflection check and a complete accessory list including wall brackets, risers and bonding kits.

BENDIN holds ISO 9001 quality certification and issues CE Declarations of Conformity. The standards above state the design and test basis of this product; third party test reports or national approvals are supplied on request and are not implied unless confirmed in the contract.

Dimensions, rung spacing and surface treatment are produced to project drawings. Load and deflection calculations are issued for spans above 3 m.

• Hyperscale and colocation data halls
• Telecom and edge computing rooms
• Overhead power distribution above server rows
• Laboratories, broadcast and control rooms
• Commercial risers and plant rooms

Q: Why aluminum instead of galvanized steel in a data hall?
A: Aluminum is non magnetic, so it does not concentrate flux or carry induced currents beside heavy feeders, and it weighs about one third of steel, which reduces ceiling dead load and hanger count.

Q: Does the ladder need earthing?
A: Yes, metallic ladders must be bonded. We supply couplers and bonding jumpers so continuity is maintained at every joint, and continuity values are recorded for the electrical inspector.

Q: Which module lengths are available?
A: Standard modules are 2000 mm and 3000 mm, with lengths up to 6000 mm produced to drawing so long runs need fewer joints and fewer bonds.

Q: What is the minimum order and delivery time?
A: Minimum order is 600 pcs with 25 working day delivery, packed on pallets for crane offloading, on L/C, T/T or D/P terms.